Item no.: 20370
- Description
- Movie
- Documents
Antares kit with GRP fuselage and laser-cut wooden parts as well as fittings. Further accessories, such as the rigging set and sails, are needed to complete the boat.
Realistic cutter yacht
The ANTARES is a cutter-tailed racing and touring yacht in the typical style of the 1920s with excellent sailing characteristics - even in stronger winds. Manfred Kaiser-Pletscher, MKP Modellbau, developed this model. The aim was to enable a model of this class with modern production processes also for the advanced beginner. The Antares is a special model for lovers of classic yachts due to its realistic appearance in detail, laser wooden deck and mahogany superstructures.
The model is certainly not a mass-produced model; although a finished epoxy hull is included in the kit and all wooden parts for the deck and superstructure are also available as laser parts, making construction quick and uncomplicated. The deck is completed completely outside the hull as a separate supporting assembly and only then glued into the hull as a whole. All materials required for construction are included. Only the fittings for rigging the mast, such as brass blocks, shroud tensioners, stainless steel cable, lines are included in the specially supplied rigging set, which is only needed later. For calm, an auxiliary drive has been installed in the model, which is available as an additional accessory set.
Drawings for the sails are included in 1:1. You can either purchase fabric to sew yourself or a finished set of sails. The detailed building instructions, in which each stage of construction is shown in pictures, and also describes the detailed control of the two headsails true to the original, and a detailed building plan make the construction of the model also possible for the non-expert without any problems. The equipment can be equipped with 2 or 3 sailing winches. The winches can also only be installed after the model has been completed.
Required accessories
Article No.
20371 Rigging set with blocks, shroud tensioners and accessories for rigging the RC model
61900 Sailcloth or
61915 Sail set ready sewn
60108 Ballast 500 g (7 packs)
79054 Servo standard size
Article No.
20371 Rigging set with blocks, shroud tensioners and accessories for rigging the RC model
61900 Sailcloth or
61915 Sail set ready sewn
60108 Ballast 500 g (7 packs)
79054 Servo standard size
79074 Winch mainsail 14 kg (1 piece)
79073 Winch foresail 10 kg (2 pieces)
79073 Winch foresail 10 kg (2 pieces)
42370 Drive set with electric motor, shaft, stern tube, coupling and propeller
67051 Speed controller
67051 Speed controller
Remote control, at least 4 channels with dual-rate function
Technical Specifications
Scale 1:20
Length 1260 mm
Width 220 mm
Mast height above deck 1240 mm
total height 1530 mm
Sail area 0.6 sqm
Weight approx. 6.5 kg
Experience level assembly (1=very easy ... 5=experts only) | |
3 Experienced | *** |
Category | |
RC Model | |
Experience level usage | |
Advancer | +++ |
Power unit | |
Electric motor | |
Sails | |
Dimensions | |
Scale | 1:20 |
Total length | 1260 mm |
Beam | 220 mm |
Height | 1530 mm |
Weight | ca. 6,5 kg |
Design | |
Materials hull | GFK |
Materials superstructure | Holz |
Hull design | Laminierter Epxoyrumpf mit Holzspanten |