Waco ARE - 35" Wingspan

Waco ARE - 35" Wingspan

Another rare subject is our laser cut model of the famous Waco ARE. A proven electric R/C flyer designed by Pat Tritle to use off the shelf flying packages.

Kit features:
Laser cut parts
Hand-selected balsa
Full size plans
Step-by-step instructions
Vacuum-molded parts
Lightweight colored tissue


FEATURES

Construction: Laser cut balsa
Wing: Two piece with center section, high mount placement
Covering: Two sheets of red and two sheets of white tissue
Cowl: Vacuum molded plastic, white in color
Wheels: Two 1.75" (45mm) diameter lightweight foam main wheels and one 0.75" (19mm) plastic tail wheel
Windows: Three sheets acetate with pattern in manual for all windows


INCLUDES

All required balsa, One sheet of yellow tissue, cowl, one fake engine decal, two wheels, one sheet, hardware, instruction manual and two full-size plan sheets.


REQUIREMENTS

Electric Motor: GWS "A" or MPI EPU-6 drive unit
Radio: 3-channel with micro size receiver
Servos: Two micro size for rudder and elevator
Electronic Speed Control: 5A with BEC
Battery: 7.4V 700mAh Lithium Polymer
Propeller: 9x7 for electric application
Finish For Covering: Butyrate dope such as Midwest Aerogloss, lightweight Mylar covering can also be used, see COMMENTS
Building and field equipment


SPECIFICATIONS

Wingspan: 35" (889mm)
Center of Gravity (CG): 2-7/16"(62mm) from the leading edge of the
wing measured at the fuselage
Control Throws:
Elevator: up and down 3/4" (19mm)
Rudder: left and right 5/8" (16mm)
Airfoil: Flat bottom

COMMENTS
Do not use Ultra Cote or MonoKote covering. It is too heavy and will shrink too much damaging the lightweight structures.