- Description
- Documents
Complete kit of a functioning windlass
This electric anchor winch allows an anchor of your ship model to fall freely
and lift slowly. The anchor winch can be built with either one or two winch
drums. The version with 2 drums is intended for simultaneous anchor dropping and
lifting provided by two anchors. In the version with the large one-piece drum
longer or thicker anchor chains can be used.
This is controlled via a proportional channel with a servo that holds the
armature in zero position, pulls up the armature in one direction and disengages
the gear motor in the other direction. A slip clutch ensures that when an anchor
is hooked or high up, nothing can happen if the engine is not switched off. In
your ship model, the winch is mounted below deck. It can also be used for other
wind activities on ship models.
The winch is delivered as a mounting kit and is completed in 2-3 hours. It
consists of plastic parts, gear motor, a servo, switches, parts for the clutch
and all screws, small parts and installation instructions.
Technical specifications:
Width over all 60 mm
Length 130 mm
Height 60 mm
Weight cpl. about 140 g
Operating voltage 6V
The kit of the anchor winch with the order no. 63512 replaces anchor winches
with order numbers 65210 and 65211.
